Internet Engineering Task Force (IETF)
Request for Comments: 6034
Category: Standards Track
ISSN: 2070-1721
D. Thaler
Microsoft
October 2010

Unicast-Prefix-Based IPv4 Multicast Addresses

Abstract

This specification defines an extension to the multicast addressing architecture of the IP Version 4 protocol. The extension presented in this document allows for unicast-prefix-based assignment of multicast addresses. By delegating multicast addresses at the same time as unicast prefixes, network operators will be able to identify their multicast addresses without needing to run an inter-domain allocation protocol.

Status of This Memo

This is an Internet Standards Track document.

This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Further information on Internet Standards is available in Section 2 of RFC 5741.

Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at http://www.rfc-editor.org/info/rfc6034.

Copyright Notice

Copyright © 2010 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . . . 2
   2.  Terminology . . . . . . . . . . . . . . . . . . . . . . . . . . 3
   3.  Address Space . . . . . . . . . . . . . . . . . . . . . . . . . 3
   4.  Examples  . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
   5.  Security Considerations . . . . . . . . . . . . . . . . . . . . 4
   6.  IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 5
   7.  Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . . 5
   8.  References  . . . . . . . . . . . . . . . . . . . . . . . . . . 5
     8.1.  Normative References  . . . . . . . . . . . . . . . . . . . 5
     8.2.  Informative References  . . . . . . . . . . . . . . . . . . 5

1. Introduction

RFC 3180 [RFC3180] defines an allocation mechanism (called "GLOP") in 233/8 whereby an Autonomous System (AS) number is embedded in the middle 16 bits of an IPv4 multicast address, resulting in 256 multicast addresses per AS. Advantages of this mechanism include the ability to get multicast address space without an inter-domain multicast address allocation protocol, and the ease of determining the AS that was assigned the address for debugging and auditing purposes.

Some disadvantages of GLOP include:

  • RFC 4893 [RFC4893] expands the size of an AS number to 4 bytes, and GLOP cannot work with 4-byte AS numbers.
  • When an AS covers multiple sites or organizations, administration of the multicast address space within an AS must be handled by other mechanisms, such as manual administrative effort or the Multicast Address Dynamic Client Allocation Protocol (MADCAP) [RFC2730].
  • During debugging, identifying the AS does not immediately identify the correct organization when an AS covers multiple organizations.
  • Only 256 addresses are automatically available per AS, and obtaining any more requires administrative effort.

More recently, a mechanism [RFC3306] has been developed for IPv6 that provides a multicast range to every IPv6 subnet, which is at a much finer granularity than an AS. As a result, the first three disadvantages above are avoided (and the last disadvantage does not apply to IPv6 due to the extended size of the address space).

Another advantage of providing multicast space to a subnet, rather than just to an entire AS, is that multicast address assignments within the range need only be coordinated within the subnet.

This document specifies a mechanism similar to [RFC3306], whereby a range of global IPv4 multicast address space is provided to each organization that has unicast address space. A resulting advantage over GLOP is that the mechanisms in IPv4 and IPv6 become more similar.

This document does not obsolete or update RFC 3180, as the mechanism described in RFC 3180 is still required for organizations with prefix allocations more specific than /24. Organizations using RFC 3180 allocations may continue to do so. In fact, it is conceivable that an organization might use both RFC 3180 allocations and the allocation method described in this document.

2. Terminology

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].

3. Address Space

A multicast address with the prefix 234/8 indicates that the address is a Unicast-Based Multicast (UBM) address. The remaining 24 bits are used as follows:

   Bits:  |   0 thru 7   |         8 thru N        |   N+1 thru 31   |
          +-------+--------------------+-----------------------------+
   Value: |     234      |      Unicast Prefix     |    Group ID     |
          +-------+--------------------+-----------------------------+

For organizations with a /24 or shorter prefix, the unicast prefix of the organization is appended to the common /8. Any remaining bits may be assigned by any mechanism the organization wishes.

For example, an organization that has a /16 prefix assigned might choose to assign multicast addresses manually from the /24 multicast prefix derived from the above method. Alternatively, the organization might choose to delegate the use of multicast addresses to individual subnets that have a /24 or shorter unicast prefix, or it might choose some other method.

Organizations with a prefix length longer than 24 do not receive any multicast address space from this mechanism; in such cases, another mechanism must be used.

Compared to GLOP, an AS will receive more address space via this mechanism if it has more than a /16 for unicast space. An AS will receive less address space than it does from GLOP if it has less than a /16.

The organization that is assigned a UBM address can be determined by taking the multicast address, shifting it left by 8 bits, and identifying who has been assigned the address space covering the resulting unicast address.

The embedded unicast prefix MUST be a global unicast prefix (i.e., no loopback, multicast, link-local, or private-use IP address space). In addition, since global unicast addresses are not permanently assigned, UBM addresses MUST NOT be hard-coded in applications.

4. Examples

The following are a few examples of the structure of unicast-prefix- based multicast addresses.

  • Consider an organization that has been assigned the global unicast address space 192.0.2.0/24. This means that organization can use the global multicast address 234.192.0.2 without coordinating with any other entity. Someone who sees this multicast address and wants to find who is using it can mentally shift the address left by 8 bits to get 192.0.2.0, and can then look up who has been assigned unicast address space that includes that address.
  • Consider an organization that has been assigned a larger address space, x.y.0.0/16. This organization can use the global multicast address space 234.x.y.0/24 without coordinating with any other entity, and can assign addresses within this space by any mechanism the organization wishes. Someone who sees a multicast address (say) 234.x.y.10 and wants to find who is using it can mentally shift the address left by 8 bits to get x.y.10.0, and can then look up who has been assigned unicast address space that includes that address.

5. Security Considerations

The same well-known intra-domain security techniques can be applied as with GLOP. Furthermore, when dynamic allocation is used within a prefix, the approach described here may have the effect of reduced exposure to denial-of-service attacks, since the topological area within which nodes compete for addresses within the same prefix is reduced from an entire AS to only within an individual organization or an even smaller area.

6. IANA Considerations

IANA has assigned a /8 in the global IPv4 multicast address space for this purpose.

7. Acknowledgments

This document was updated based on feedback from the MBoneD working group. In particular, Tim Chown, Toerless Eckert, Prashant Jhingran, Peter Koch, John Linn, Dave Meyer, Pekka Savola, Greg Shepherd, and Stig Venaas provided valuable suggestions on the text.

8. References

8.1. Normative References

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119, March 1997.

8.2. Informative References

   [RFC2730]  Hanna, S., Patel, B., and M. Shah, "Multicast Address
              Dynamic Client Allocation Protocol (MADCAP)", RFC 2730,
              December 1999.
   
   [RFC3180]  Meyer, D. and P. Lothberg, "GLOP Addressing in 233/8",
              BCP 53, RFC 3180, September 2001.
   
   [RFC3306]  Haberman, B. and D. Thaler, "Unicast-Prefix-based IPv6
              Multicast Addresses", RFC 3306, August 2002.
   
   [RFC4893]  Vohra, Q. and E. Chen, "BGP Support for Four-octet AS
              Number Space", RFC 4893, May 2007.

Author's Address

   Dave Thaler
   Microsoft Corporation
   One Microsoft Way
   Redmond, WA  98052
   USA
   
   Phone: +1 425 703 8835
   EMail: dthaler@microsoft.com